Back Forum New

Structure Features of Ore Milling Equipment

Ore Milling Equipment is the key equipment for crushing the material after being broken. Ore Milling Equipment is widely used in gold, cement, silicate products, new building materials, refractory materials, chemical fertilizer, black and non-ferrous metal processing, such as glass ceramics industry production of all kinds of ores and other materials may be grinding of dry or wet grinding.

Structure Features of Ore Milling Equipment

The Ore Milling Equipment is composed of feeding parts, discharging parts, rotating parts, transmission parts (reducer, small transmission gear, motor, electrical control) and other major parts. The hollow shaft is made of cast steel, the inner lining can be replaced, the big turning gear adopts the casting hobbing process, and the inside of the cylinder is provided with a wear-resistant lining board. The utility model has good abrasion resistance, and the machine runs smoothly and has reliable performance. Dry powder mill and wet lattice type Ore Milling Equipment can be selected according to material and ore discharge mode.

Wearing parts of Ore Milling Equipment

The wearing parts of micro powder grinding mill mainly refer to lining board, and the wear and service life of lining board is related to the cost and production effect of micro grinding. So how to identify the pros and cons of lining board, mainly from three aspects to see, first look at the casting and melting process of lining plate, followed by quenching and tempering of the lining board is qualified, finally see liner material, currently on the market common liner material with high chromium cast iron, cast steel, low alloy wear resistance high manganese steel materials, lining plate has good wear resistance of three kinds of material. Welcome to our factory to investigate the production process of Ore Milling Equipment and its lining board.

Ore Milling Equipment Working principle

Material from the feed devicefeedair evenly into the spiral grinding first warehouse, the warehouse has stepped lining board or corrugated liner, built in different specifications of steel tube to rotate the ball to a certain height, the centrifugal force generated after the fall, pounding and abrasivematerials. When the material reaches rough grinding in the first bin, it enters the second warehouse through a single partition board. It is equipped with a flat lining board with steel balls in it and further grinding the material. The powder is discharged through the discharging grate plate to complete the grinding operation.

Bookmark and Share


Back Forum